Woodstock W1811 - Manual (Page 43)

-41-
N(/((('Jc`[`e^KXYc\JXn
FG
<
I
8
K@FEJ
I`g:lkk`e^n`k_I`g=\eZ\
(% Slide the crosscut table out of the way.
)% Lock the sliding table into a stationary position (see
=`^li\-/).
Efk\1K_\kXYc\n`ccfecpcfZb`egcXZ\n_\e`k`j
Z\ek\i\[n`k_k_\jXnZXY`e\k%
+% Slide the leading end of the rip fence so it is even
with the center of the main saw blade as shown in
=`^li\.'.
Efk\1K_`jk\Z_e`hl\Xccfnjk_\]`e`j_\[Zlk$f]]
g`\Z\kfÈ]XccÉXnXp]ifdk_\YcX[\n_\ek_\Zlk$
k`e^fg\iXk`fe`jZfdgc\k\2i\[lZ`e^k_\gfjj`Y`c`kp
f]b`ZbYXZb%
*% Place the rip fence in the vertical position for larger
workpieces, or in the horizontal position for angled
cuts and for small workpieces (see
=`^li\-0).
,% Tighten the lock handles (=`^li\.() to secure the
rip fence against the base.
-% Pull up the lock lever to loosen the fence base on
the rail, position the fence at the correct distance
away from the blade (as needed for the cut), then
push down the lock lever to lock the fence base in
position.
.% Take all the necessary safety precautions, then make
the cut as you would with a traditional table saw.
Figure .'. Rip fence even with center of
blade (blade guard removed for clarity).
Rip Fence
Table Lock
=`^li\-/% Sliding table lock.
=`^li\-0% Rip fence positions.
Horizontal
Vertical
Lock
Lever
=`^li\.(% Rip fence micro-adjusting controls.
Lock
Handles