Woodstock W1811 - Manual (Page 44)

-42-
N(/((('Jc`[`e^KXYc\JXn
FG
<
I
8
K@FEJ
:ifjjZlkk`e^
This saw can crosscut full size panels with the crosscut
fence in the forward or rear position, although it is easier
to load full size panels with the crosscut fence mounted
in the forward position (see
=`^li\.)).
Mounting the crosscut fence in the rear position ( =`^li\
.*) gives greater stability for crosscutting smaller panels.
In addition, this machine has the capability of crosscutting
workpieces while using the rip fence as a cut-off gauge
(
=`^li\ .+)—as long as the rip fence is positioned in front
of the blade (see =`^li\.').
Determine which cutting operation will be best suited for
the workpiece to be crosscut.
— If you will be crosscutting full size panels, then
skip ahead to :ifjjZlkk`e^=lccJ`q\GXe\cj.
— If you will be crosscutting smaller panels, then
skip ahead to :ifjjZlkk`e^JdXcc\iGXe\cj.
— If you will be crosscutting workpieces using the
rip fence as a cut-off gauge, then skip ahead to
:ifjjZlkk`e^Lj`e^I`g=\eZ\XjX:lk$F]]>Xl^\.
Figure .+. Crosscutting workpieces
using the rip fence as a cut-off gauge.
Figure .). Crosscut fence mounted in
forward position.
Forward Mounted
Crosscut Fence
Figure .*. Crosscut fence mounting in rear
position.
Rear Mounted
Crosscut Fence