Woodstock W1811 - Manual (Page 32)

-30-
N(/((('Jc`[`e^KXYc\JXn
FG
<
I
8
K@FEJ
FG
>\e\iXc
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
If you are an inexperienced operator, we strongly
recommend that you read books, industry magazines,
or seek training from an experienced
Jc`[`e^KXYc\JXn
operator before performing any unfamiliar operations.
Above all, your safety should come first!
8cnXpjn\XijX]\kp^cXjj\jn_\efg\i$
Xk`e^ k_`j dXZ_`e\% =X`cli\ kf Zfdgcp
dXpi\jlck`ej\i`fljg\ijfeXc`ealip%
I<8;Xe[le[\ijkXe[k_`j\ek`i\`ejkilZ$
k`fe dXelXc Y\]fi\ lj`e^ k_`j dXZ_`e\%
J\i`flj g\ijfeXc `ealip dXp fZZli `]
jX]\kpXe[fg\iXk`feXc`e]fidXk`fe`jefk
le[\ijkff[ Xe[ ]fccfn\[% ;F EFK i`jb
pflijX]\kpYpefki\X[`e^
;FEFK`em\jk`^Xk\gifYc\djfiX[aljk
k_\ dXZ_`e\ n_`c\ `k `j ilee`e^% NX`k
lek`c k_\ dXZ_`e\ `j klie\[ F==#
legcl^^\[ Xe[ Xcc nfib`e^ gXikj
_Xm\Zfd\kfXZfdgc\k\jkfgY\]fi\
gifZ\\[`e^
JX]\kp?XY`kj
Your safety is important. Always think about safety
when operating this machine. The operator is ultimately
responsible for their own safety, as well as the safety
of bystanders. Every cutting operation is different and
may require safety equipment or safety procedures not
mentioned in this manual. Use common sense!
=fccfnk_\j\jX]\kpk`gj
• Stand to the left of the blade line-of-cut when
performing a cutting operation.
• Turn the saw F== and allow the blade to come to a
complete stop before removing the cut-off piece.
• Make sure that the riving knife is always aligned with
the main blade before cutting!
• Always make sure the blade guard is installed and
works correctly.
• Carefully plan each cutting operation to avoid
injuries.
• When you release the sliding table lock, make sure
that the knob is positioned so that it will not lock
the table during a cut.