Woodstock W1811 - Manual (Page 23)

-21-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
=`^li\)*% Support leg installed.
Support Leg
Extension
Arm
Attachment
Location
(,% Place a 12mm flat washer on the crosscut table
lock lever, then insert it through the crosscut
fence and thread the M12-1.75 T-nut onto the end
approximately two turns.
(-% Align the T-nuts on the crosscut table with the
T-slot in the face of the sliding table, then slide
the crosscut table into position on the sliding table
(
=`^li\))) and tighten the crosscut table lock lever.
=`^li\))% Crosscut table installation.
T-Slot
Lock Lever
(.% Place the crosscut table support leg on the extension
arm, and attach it to the crosscut table with four
M6-1 x 16 cap screws, 6mm lock washers, and 6mm
flat washers.
(/% Insert the two crosscut brace knobs with 8mm flat
washers through the crosscut table, then thread
the square nuts onto the ends of the knob threads
(
=`^li\)+#8). Slide the T-slot in the support bar
over both T-nuts, and tighten the knobs ( =`^li\)+#
9).
Jlggfik
9Xi
BefY
D/$(%),o,'
JhlXi\Elk
D/$(%),
:ifjjZlk
KXYc\
=cXkNXj_\i
/dd
9
8
=`^li\)+% Installing support bar on
crosscut table.
T-Nut