Woodstock W1811 - Manual (Page 30)

-28-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
=`^li\+,% Power connection box.
Power
Connection Box
Figure +-. Power connection terminals.
R
Ground
S
Before connecting the saw to power, read through
section on GX^\() to verify that your setup
follows the safety and circuit requirements for this
machine.
Open the power connection box shown in =`^li\+,.
Gfn\i:fee\Zk`fe
Connect the power wires to the terminals shown in =`^li\
+-, tighten the strain relief so the wires can't be pulled
from the terminals, then close the power connection box.
=`^li\+.% Main power controls.
ON Button
STOP Button
K\jkIle
Once the assembly is complete and the power source is
connected, test run your machine to make sure it runs
properly and is ready for regular operation.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, 2) the stop button
safety feature works correctly, and 3) the safety limit
switches work correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, immediately stop using
the machine, then review
KiflYc\j_ffk`e^ on GX^\-).
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
Before beginning the test run, review the power controls
shown in
=`^li\+. and :fekifcj=\Xkli\j on GX^\*.