Woodstock W1811 User Manual
Page 27
-25-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
*+% Install the riving knife as shown in =`^li\*-, but do
not tighten the mounting bolt yet.
Efk\1N_`c\k_\dflek`e^Yfck`jcffj\#k_\i`m`e^
be`]\ZXeY\X[aljk\[lgfi[fne%
=`^li\*-% Installing riving knife.
=`^li\*.% Adjusting the riving knife
spacing.
*,% Adjust the riving knife approximately
1
⁄
8
" away from
the main blade, using a
1
⁄
8
" or 3mm hex wrench as a
guide (
=`^li\*.), and make sure the top of the riv-
ing knife is positioned below the blade's highest point
of rotation, as shown in
=`^li\,) on GX^\*+.
*-% Use a straightedge to make sure the riving knife and
scoring blade are aligned with the main blade.
— The riving knife position can be modified slightly
by shimming. Refer to
GX^\*, for more details.
— The scoring blade alignment can be changed by
adjusting the set screws accessible through the
table top (see
=`^li\*/or refer to GX^\*.).
=`^li\*/% Access holes for scoring blade
adjustment controls.
Scoring Controls Lock
Scoring Blade Elevation
Scoring Blade
Alignment