Woodstock W1811 - Manual (Page 24)

-22-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
(0% Slide the pivot stud assembly and the M8-1.25 x 60
T-bolt into the crosscut fence T-slot, as shown in
=`^li\),.
)'% Align the T-bolt and pivot stud with the crosscut
table insertion points ( =`^li\),), and install the
fence on the table.
)(% Thread the M8-1.25 knob with an 8mm flat washer
onto the bottom of the T-bolt from the underside of
the table.
=`^li\),% Pivot stud and T-bolt installed
in crosscut fence.
T-Bolt M8-1.25 x 60
Pivot Stud
Assembly
%%%kfK$Yfck
BefY
D/$(%),o,,
=cXkNXj_\i
/dd
))% Hold the crosscut fence against the positive stop
bolt, shown in =`^li\)-, then tighten the knob
underneath the crosscut table to lock the crosscut
fence in position.
Efk\1K_`jgfj`k`m\jkfgYfckZXeY\]`e\$kle\[cXk\i
kf\ejli\k_Xkk_\ZifjjZlk]\eZ\`jjhlXi\kfk_\
YcX[\%
=`^li\)-% Positive stop bolt against the
crosscut fence.
Positive
Stop Bolt
)*% Install the flip stops in the T-slot on the crosscut
fence, as shown in =`^li\)., and use the crosscut
fence lock knob to secure the extendable end of the
fence in position.
=`^li\).% Flip stops installed on crosscut
fence.
Flip Stops
Crosscut Fence Lock Knob
M8-1.25 x 25