Woodstock W1811 - Manual (Page 20)

-18-
N(/((('Jc`[`e^KXYc\JXn
J<
K
L
G
Before shipping, the sliding table was installed on the
machine and calibrated to the main table and blade. As
such, be careful not to move any pre-installed nuts when
installing the sliding table.
The sliding table and extension tables are heavy, so use
a forklift or four strong helpers to lift the sliding table
during installation.
KfXjj\dYc\k_\jc`[`e^kXYc\jXn#[fk_\j\jk\gj1
(. Place the sliding table on the cabinet.
). On each side of the sliding table, slide a T-stud
down the center bottom T-slot until it is next to the
mounting bracket.
*. Lift one side of the sliding table, position the T-stud
over the hole in the mounting bracket, then lower
the sliding table so the T-stud fits through the hole,
as shown in
=`^li\(*. Repeat on the other side.
+. Put a 12mm flat washer, 12mm lock washer and M12-
1.75 hex nut on the bottom of each T-stud and tight-
en the hex nut to secure the sliding table in place.
,. Install the small extension table with the two M10-
1.5 x 25 cap screws, 10mm flat washers and 10mm
lock washers (see
=`^li\(+).
-% Thread one M8-1.25 hex nut halfway onto each of
the M8-1.25 x 25 set screws, then install two of the
set screws where shown in
=`^li\(+, to act as lev-
eling screws in a later step.
.% Install the large extension table with the three M10-
1.5 x 25 cap screws, 10mm flat washers, and 10mm
lock washers (see
=`^li\(,).
/% Thread four M8-1.25 x 25 set screws with hex nuts
where shown in =`^li\(,, to act as leveling set
screws in a later step.
0% Level the top of the extension tables even with the
top of the cast iron table.
Using a straightedge as a guide ( =`^li\(-), adjust
the leveling set screws to align the top of the exten-
sion tables with the top of the cast iron table.
Tighten the hex nuts on the leveling screws against
the extension table to lock the screws when the
tables are aligned.
8jj\dYcpJ\klg
=`^li\(*% T-stud inserted in mounting
bracket.
T-Stud Inserted
Through Mounting
Bracket
=`^li\(+% Small extension table installed.
Mounting Cap Screws
Leveling Set Screws
=`^li\(,% Large extension table installed.
Mounting Cap Screws
Leveling Set Screws
=`^li\(-% Extension wings mounted and
even with cast iron table.