Woodstock W1811 - Manual (Page 55)

-53-
N(/((('Jc`[`e^KXYc\JXn
D
8
@EK<
E8E:
<
ClYi`ZXk`fe
9\Xi`e^j1 The bearings are sealed and pre-lubri-
cated and require no lubrication.
Kilee`fej1 Use multi-purpose grease in the
trunnion grooves (
=`^li\0)) every 6–12 months,
depending on the frequency of use. To grease the
blade height trunnion, move the blade height all
the way down and smear a dab of grease into
the trunnion groove, behind the plate shown in
=`^li\0), then move the blade up all the way
to spread the grease.
To grease the blade tilt trunnions, move the
sliding table out of the way and open the blade
guard. Tilt the blade to 90°. From the front of
the saw, smear a dab of grease in the front of
the trunnion grooves on both sides. Now, tilt the
blade to 45° and reach inside the cabinet and
smear a dab of grease into the back of the trun-
nion grooves on both sides. Tilt the blade back-
and-forth to distribute the grease evenly.
=`^li\0(% Sliding table ways.
Sliding Table Way Steel Rod
=`^li\0)% Lubrication locations (table removed for clarity).
Blade Height Trunnion
(Grease Behind This
Plate)
Leadscrews
Blade Tilt
Trunnions
C\X[jZi\nj1 Use multi-purpose grease on the
leadscrews (
=`^li\ 0)) every 6-12 months, at
the same time you lubricate the trunnions. Wipe
the leadscrews clean with a dry rag and brush a
light coat of new grease on them with a clean,
dry brush. Only grease the area of the leadscrew
between the stop nuts. Move the blade height
and tilt the blade back-and-forth to distribute
the grease evenly.
Jc`[`e^KXYc\NXpj1 Spray/wipe on a light
machine oil (such as Boeshield) down the entire
length of the steel rods (
=`^li\0().