Sharp UX-CD600 - Manual (Page 75)

Transfer Function
73
3. Ans
w
er
ing
System
Transfer Function
The Transfer function is used to have the machine automatically call you at a
specified number every time it receives an incoming message in a specified
box. This lets you hear your messages immediately after they come in, even
when you are at a remote location.
To use the Transfer function, you must first program the number that you wish
the machine to call (the transfer number), and record the transfer message
that plays when you answer the phone at the remote location.
When you go out and wish to use the transfer function, turn it on. When you
return and no longer wish to use the transfer function, turn it off.
♦
The Transfer function can be used when the machine is in either TAD mode
or Auto Attendant mode.
Hint: Use the Transfer function in Auto Attendant mode when you will be
going out but other people in your office or home will be in and will answer
calls routed to their cordless handsets.
Note: The machine will normally use line 2 to call you. Line 1 will only be used
if line 2 is busy.
Programming the transfer number
To use the Transfer function, you must first give the machine the number to
call (the transfer number).
1
Press once and once.
2
Press once and twice.
3
Press once.
4
Press the number keys to enter the transfer number.
•
To insert a pause between any two digits of the number, press .
5
Press .
FUNCTION
FUNCTION
START/MEMORY
Display:
T.A.D. SETTING
TRANSFER TEL #
ENTER TEL #
TRANSFER FUNC
all.book 73 ページ ２００４年６月２２日 火曜日 午後１２時１分