Sharp UX-CD600 - Manual (Page 127)

Problems and Solutions
125
10. T
roub
le-
shooting
Dialing and transmission problems
Problem Solution
No dial tone when you
pick up the handset or
press the SPEAKER key. • Make sure the handset cord is connected to the
correct jack. See Connecting the handset on page
16.
Dialing is not possible. • Make sure the power cord is properly plugged into
a power outlet.
• Make sure that the telephone line is properly
connected to correct jack on the machine and the
wall jack (see page 17).
• Make sure that the machine is set to the correct
dialing mode for your telephone line. See page 35.
The power is on, but no
transmission takes place. • Make sure that the receiving machine has paper.
• If the receiving machine is in manual mode with no
attendant, reception will not be possible.
• Check the display for error messages.
• Pick up the handset and check for a dial tone.
Nothing is printed at the
receiving end. • Make sure that the document for transmission is
placed face down in the feeder.
A distorted image is
received at the other end. • Noise on the telephone line may cause distortion.
Try sending the document again.
• Make a copy of the document on your machine. If
the copy is also distorted, your machine may need
service.
all.book 125 ページ ２００４年６月２２日 火曜日 午後１２時１分