Sharp UX-CD600 - Manual (Page 102)

Receiving Faxes Manually
100
Receiving Faxes Manually
To receive a fax manually, you must answer the call personally using the
machine handset, a cordless handset, or an extension phone connected to
the same line.
Faxes can only be received manually in TEL mode. A fax can be received
manually on line 1, or on line 2 if you answer the call before the machine
answers automatically.
Answering with the machine’s handset
Important: If a document is loaded in the machine’s feeder, remove it before
performing the steps below. (Fax reception is not possible when a document
is in the feeder.)
1
When the machine rings, pick up the
handset.
2
If you hear a fax tone, wait until the
display shows RECEIVING and then
replace the handset.
3
If the other party first speaks with you
and then wants to send a fax, press
after speaking. (Press
before the sender presses their Start
key.)
•
When RECEIVING appears in the
display, hang up.
START/MEMORY
If RECEIVING does not appear (or if you have set
the Fax Signal Receive setting to NO), press
to begin reception.
START/MEMORY
Beep
START/MEMORY
RECEIVING
RECEIVING
all.book 100 ページ ２００４年６月２２日 火曜日 午後１２時１分