SUPER MICRO Computer 5014C-MF - Manual (Page 55)

Chapter 5: Advanced Motherboard Setup
5-17
5-10 Jumper Settings
Explanation of
Jumpers
To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers
create shorts between two pins to
change the function of the connector.
Pin 1 is identifi ed with a square solder
pad on the printed circuit board. See
the motherboard layout pages for
jumper locations.
Note: On a two-pin jumper, "Closed"
means the jumper is on both pins and
"Open" means the jumper is either on
only one pin or completely removed.
CMOS Clear
JBT1 is used to clear CMOS (which will also clear any passwords). Instead of pins,
this jumper consists of contact pads to prevent accidentally clearing the contents
of CMOS. To clear CMOS,
1) First power down the system and unplug the power cord(s)
2) With the power disconnected, short the CMOS pads with a metal object such
as a small screwdriver
3) Remove the screwdriver (or shorting device)
4) Reconnect the power cord(s) and power on the system.
Speaker Connector
Use the header on J9 to enable either
the internal or an external speaker. To
use the internal system speaker, con-
nect the speaker wires to pins 3-4. If
you wish to use an external speaker,
you should jump pins 1 and 2.
Speaker Jumper
Pin Defi nitions (J9)
Setting Defi nition
Pins 1-2 External Speaker
Pins 3-4 Internal Speaker
Connector
Pins
Jumper
Setting
3 2 1
3 2 1