Savin RCP40 - Manual (Page 26)

Getting Started
20
1
Connecting the Machine to the Host Using the Parallel Cable
Connect the machine to the host computer using a parallel cable compliant with
IEEE 1284 (available separately).
Follow these steps to connect the machine to the host computer.
Important
❒ Before connecting an interface cable between the machine and a computer,
make sure that the machine is not operating, and then turn off the main power
switches of the machine and the computer.
❒ Be sure to use the designated interface cable. Using another cable may cause
radio interference.
AAAA
Plug the 36-pin end of the parallel cable into the parallel port at the right
side on the back of the machine.
BBBB
Squeeze the wire clips on each side of the connector together until they
snap into place. The clips hold the cable securely in place.
❖ ❖ ❖ ❖ Type A
❖ ❖ ❖ ❖ Type B
CCCC
Plug the other end of the parallel cable into the computer's parallel port.
If there are the wire clips, squeeze them on each side of the connector to-
gether.
ZJXH160J