Savin RCP40 - Manual (Page 19)

Network Settings
13
1
EEEE
If necessary, make the Network boot settings.
A Select [7 Network] using the {{{{~
~ ~ ~}}}} key or {{{{} } } }}}}} key.
B Press the {{{{OK}}}} key.
The network boot settings screen appears.
C Select the Network boot to be set using the {{{{~ ~ ~ ~}}}} key or {{{{} } } }}}}} key.
*1 The valid methods are in order from the left: ARP+PING, RARP+TFTP,
BOOTP, DHCP.
Note
❒ It is necessary to set the server when using RARP+TFTP, BOOTP, and
DHCP.
❒ When setting the IP address on the control panel, use None.
Reference
See Network Printing Guide when using DHCP.
D Press the {{{{OK}}}} key.
This completes the Network boot settings.
Item
Valid method *1
AP RA BO DH
ARP+PING b
ARP&RARP
b b
ARP&BOOTP b b
ARP&RARP&BOOTP
b b b
None (Factory Settings)
RARP+TFTP
b
BOOTP b
RARP&BOOTP b b
DHCP b