Model ws-30 installation, Dual installations, Flush inset panels—dual installation – Sub-Zero 427R User Manual
Page 51
Model WS-30 Installation
51
subzero.com
Dual Installations
DUAL FLUSH INSET INSTALLATIONS
Installing two models WS-30 or a model WS-30 and
built-in unit side by side in a flush inset application will
require adjustments to the dimensions of your finished
rough opening, panel sizes and panel offsets. It will also
require a dual installation kit, available through your
authorized Sub-Zero dealer.
Dual installations without a filler strip can only be accom-
plished using two units with opposite hinges as shown in
illustration A below. The dual installations shown in illus-
trations B and C require a filler strip. Illustration A is the
only application that will accommodate the dual wide
grille.
IMPORTANT NOTE:
The application shown in illustration A
can only be achieved by installing dual flush inset panels.
Failure to install dual flush inset panels will cause the
handle side of the panels to collide when closing. In this
application a dual installation accessory kit is also
required.
Dual flush inset panels and dual installation kits are avail-
able through your authorized Sub-Zero dealer. Refer to the
illustration and chart for dual flush inset panel specifica-
tions.
Flush Inset Panels—Dual Installation
Grille panel dimensions listed are for a standard 84" (2134)
overall height of the unit. For an 83" (2108) overall height,
subtract 1" (25) from grille panel height dimensions. For an
88" (2235) overall height, add 4" (102) to height dimensions.
Width dimensions do not vary.
Model WS-30
DOOR
W
H
Flush Inset Panel
30
1
/
2
"
(775)
69
3
/
4
"
(1772)
Spacer Panel
29
1
/
8
"
(740)
68
15
/
16
"
(1751)
Backer Panel
29
3
/
4
"
(756)
69
9
/
16
"
(1767)
GRILLE
W
H
Flush Inset Panel
30
1
/
2
"
(775)
9
1
/
4
"
(235)
Spacer Panel
29
1
/
8
"
(740)
8
5
/
16
"
(211)
Backer Panel
29
3
/
4
"
(756)
8
15
/
16
"
(227)
WINDOW
W
H
Cut-Out
23"
(584)
62
1
/
4
"
(1581)
A
Location
3
3
/
4
"
(95)
H
W
H
A
A
A
A