Sharp AR-337 - Manual (Page 115)

7-3
CHAPTER
7
FINISHER (AR-FN1N)
The copier has two different finisher modes: one sorts copies into sets matching the sequence of the originals and the
second groups copies by original. When the optional finisher (AR-FN1N) is installed, the copier can automatically
staple the sorted copies. Each collated set of copies or group of copies can be stacked offset from the previous set.
PART NAMES
OPTIONAL EQUIPMENT
Finisher (AR-FN1N)
● The top tray and second tray are each furnished with an extendable component, which is to be used when copying
onto size 11" x 17" paper.
Specifications
Tray capacity Top tray: 500 sheets
Second tray: 500 sheets
Offset tray: 1,500 sheets (8-1/2" x 11")
750 sheets (larger than 8-1/2" x 11")
Paper size Top tray: 5-1/2" x 8-1/2" to 11" x 17"
Second tray: 5-1/2" x 8-1/2" to 11" x 17"
Offset tray: 8-1/2" x 11" to 11" x 17"
Paper weight Top tray: 14 lbs. to 34 lbs. (when face up)
17 lbs. to 28 lbs. (when face down)
Second tray: 17 lbs. to 28 lbs.
Offset tray: 17 lbs. to 34 lbs. (when face up)
17 lbs. to 28 lbs. (when face down)
For paper weighing more than 28 lbs., 8-1/2" x 11" is
the maximum size.
Offset 1.2 inch (30 mm)
Paper size 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14", 11" x 17"
for stapling
Stapling capacity 50 sheets (20 lbs.)
(25 sheets for 8-1/2" x 14" and 11" x 17" paper)
Power supply Drawn from the copier
Weight Approx. 111 lbs. (50 k g )
Dimensions 23-15/64"(W) x 22-1/16"(D) x 39-19/64"(H)
(590 mm (W) x 560 mm (D) x 998 mm (H))
Specifications are subject to change for improvement without notice.
Finisher release lever
Top tray
Second tray
(not used in the copy mode)
Stapler unit
Paper transport area cover
Paper feed area cover
Top cover
Offset tray
When copying onto size 11” x 17”
paper, lower the metal support
located at the tip of the offset tray.