Sharp AR-337 - Manual (Page 107)

6-5
CHAPTER
6
PART NAMES AND FUNCTIONS
READY TO COPY.
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO 8/ 11 1
2
1.8/ 11
2.11 17
1
2
8/ 11 1
2
ORIGINAL
8/ 11R
1
2
CUSTOM SETTINGS key
Press to set key operator programs or adjust the
contrast of the touch panel.
2-SIDED COPY key
Press to select the 1-sided to 1-sided, 1-sided to
2-sided, 2-sided to 1-sided or 2-sided to 2-sided
copy mode.
OUTPUT key
Press to select the finisher mode: SORT or
GROUP.
SCAN key
Press to select the network scanner function.
(Optional Printer Expansion Kit and Network
Scanner Expansion Kit must be installed.)
EXPOSURE display
Indicates the selected exposure mode.
EXPOSURE key (p. 2-16)
Press to select the exposure mode: AUTO,
TEXT, TEXT/PHOTO, or PHOTO.
PAPER SELECT display
Displays the selected paper size. When “AUTO”
is displayed, paper size matching the original and
copy ratio will be automatically selected.
PAPER SELECT key
Press to select the desired paper tray.
COPY RATIO display
Displays the copy ratios for reductions or
enlargements.
COPY RATIO key
Press to select a reduction or enlargement copy
ratio or select the automatic copy ratio selection
mode.
REVIEW key
Press to check the settings of selected functions.
Initial settings
The copier assumes the initial settings when the
CLEAR ALL (
CA
) key is pressed and approximately 1
minute after the last copy is made in any mode.
Except for the paper tray selection, the copier also
assumes the initial setting when it is turned on.
● Copy ratio: 100%
● Automatic exposure
● Copy quantity: 0
● All special copier modes are set to off.
● Tray select: Paper tray 1 (At power on, the
previously selected tray will again be selected.)
Optional large capacity tray will be selected when
installed.
★ KEY OPERATOR Initial settings can be
programmed as desired. The auto clear time can also
be changed. See pages 17 and 21 of the KEY
OPERATOR’S GUIDE.
GENERAL INFORMATION Part names and functions
Touch Panel (Basic screen)