Routing command – Sony RS-232C User Manual
Page 54

– 54 –
ROUTING : 43[H] 52[H] 4C[H] 31[H]-38[H] (‘CRL1-8’)
43[H] 52[H] 52[H] 31[H]-32[H] (‘CRR1-2’)
This command is used to set the routing for the OUTPUT channels.
Various setups can be memorized in the scene memories by specifying these scene Nos.
The commands that correspond to the respective channels are shown below.
•
Packet format
43[H] 52[H] 4C[H] 31[H] “parameter” 0D[H]
(In the case of LINE OUTPUT1)
•
Parameter
The parameter consists of the 20 bytes all the time in the order as shown in the table below.
When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.
At the same time, when you specify the scene No.(31[H] (‘1’) through 44[H] (‘D’)), parameters of the subsequent 2nd through 20th byte
are written in the scene memory.
For the method of setting the scene No., see the GROUP FADER command (pages 29 and 30).
CHANNEL
Command
LINE OUTPUT 1
43[H] 52[H] 4C[H] 31[H] ‘CRL1’
LINE OUTPUT 2
43[H] 52[H] 4C[H] 32[H] ‘CRL2’
LINE OUTPUT 3
43[H] 52[H] 4C[H] 33[H] ‘CRL3’
LINE OUTPUT 4
43[H] 52[H] 4C[H] 34[H] ‘CRL4’
LINE OUTPUT 5
43[H] 52[H] 4C[H] 35[H] ‘CRL5’
LINE OUTPUT 6
43[H] 52[H] 4C[H] 36[H] ‘CRL6’
LINE OUTPUT 7
43[H] 52[H] 4C[H] 37[H] ‘CRL7’
LINE OUTPUT 8
43[H] 52[H] 4C[H] 38[H] ‘CRL8’
REC OUT 1
43[H] 52[H] 52[H] 31[H] ‘CRR1’
REC OUT 2
43[H] 52[H] 52[H] 32[H] ‘CRR2’
byte
Parameter name
byte
Parameter name
1st
SCENE No.
11 th
LINE4 A-C,F R LEVEL
2nd
MIC1/WL1 LEVEL
12 th
LINE4 D-E L LEVEL
3rd
MIC2/WL2 LEVEL
13 th
LINE4 D-E R LEVEL
4th
MIC3 LEVEL
14 th
LINE4 D-E LS LEVEL
5th
MIC4 LEVEL
15 th
LINE4 D-E RS LEVEL
6th
MIC5/LINE1 LEVEL
16 th
LINE4 D-E C LEVEL
7th
MIC6/LINE2 LEVEL
17 th
LINE4 D-E SW LEVEL
8th
LINE3 L LEVEL
18 th
MIC1/WL1-MIC6/LINE2 ON/OFF
9th
LINE3 R LEVEL
19 th
LINE3-LINE4A-C ON/OFF
10th
LINE4 A-C,F L LEVEL
20 th
LINE4 D,E ON/OFF