Sony RS-232C - Manual (Page 41)

– 41 –
LINE OUTPUT3-8 PARAMETER REQUEST :
52[H] 4F[H] 4D[H] 33[H]-38[H] (‘ROL3-8’)
This command is used to read the setup of any desired single channel of the LINE OUTPUT 3 to 8 from the SRP-X700P.
The commands that correspond to the respective channels are shown below.
• Packet format
52[H] 4F[H] 4C[H] 33[H] “parameter” 0D[H]
(In the case of LINE OUTPUT 3)
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the
order shown below.
41[H] “parameter” 0D[H]
The parameter is the same as the 25 bytes of the LINE OUTPUT 3 through 8 commands’ parameter from which the scene No. is
exempted.
MIC INPUT : 43[H] 49[H] 4D[H] 31[H]-36[H] (‘CIM1-6’)
This command is used to implement setting up the desired single channel of the MIC1/WL1 to MIC6/LINE2 input channels.
Various setups can be memorized in the scene memories by specifying these scene Nos.
The commands that correspond to the respective channels are shown below.
CHANNEL Command
LINE OUTPUT 3 43[H] 4F[H] 4C[H] 33[H] ‘ROL3’
LINE OUTPUT 4 43[H] 4F[H] 4C[H] 34[H] ‘ROL4’
LINE OUTPUT 5 43[H] 4F[H] 4C[H] 35[H] ‘ROL5’
LINE OUTPUT 6 43[H] 4F[H] 4C[H] 36[H] ‘ROL6’
LINE OUTPUT 7 43[H] 4F[H] 4C[H] 37[H] ‘ROL7’
LINE OUTPUT 8 43[H] 4F[H] 4C[H] 38[H] ‘ROL8’
CHANNEL Command
MIC1/WL1 43[H] 49[H] 4D[H] 31[H] (‘CIM1’)
MIC2/WL2 43[H] 49[H] 4D[H] 32[H] (‘CIM2’)
MIC3 43[H] 49[H] 4D[H] 33[H] (‘CIM3’)
MIC4 43[H] 49[H] 4D[H] 34[H] (‘CIM4’)
MIC5/LINE1 43[H] 49[H] 4D[H] 35[H] (‘CIM5’)
MIC6/LINE2 43[H] 49[H] 4D[H] 36[H] (‘CIM6’)