Sony RS-232C User Manual
Page 40

– 40 –
•
Parameter
The parameter consists of the 26 bytes all the time in the order as shown in the table below.
When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.
At the same time, when you specify the scene No.(31[H] (‘1’) through 44[H] (‘D’)), parameters of the subsequent 2nd to 26th bytes are
written in the scene memory.
For the method of setting the scene No. and index, refer to the GROUP FADER command (pages 29 and 30).
Method of setting the PEQ1-4 frequency, PEQ1-4 Q, PEQ1-4 Gain, Gain Limit and fader level is the same as that of the LINE 3 INPUT
command. See pages 32 to 35.
Method of setting the REF LEVEL, Function ON/OFF and delay is the same as that of the LINE OUTPUT1 and 2 commands. See page
37.
For the packet example, see the example of the LINE 3 INPUT command on page 35. However, the parameter length becomes 26 bytes.
•
REF LEVEL (10th byte)
This command is used to set the reference output level [dBu].
byte
Parameter name
byte
Parameter name
1st
SCENE No.
18 th
PEQ3 Frequency
2nd-9th
INDEX
19 th
PEQ3 Q
10 th
REF LEVEL
20 th
PEQ3 GAIN
11 th
FUNCTION ON/OFF
21 st
PEQ4 Frequency
12 th
PEQ1 Frequency
22 nd
PEQ4 Q
13 th
PEQ1 Q
23 rd
PEQ4 GAIN
14 th
PEQ1 GAIN
24 th
DELAY
15 th
PEQ2 Frequency
25 th
GAIN LIMIT LEVEL
16 th
PEQ2 Q
26 th
FADER LEVEL
17 th
PEQ2 GAIN
REF LEVEL
-10
30[H] (‘0’)
-5
35[H] (‘5’)
0
3A[H] ‘:’)
(