Motorola i2000 - Manual (Page 3)

Introduction 3 English
Getting Started
In order to get started straight away with your new i2000, follow
these steps:
Charge the Battery
! Before you use your phone, please read the following
for important information on battery charging.
1 Remove the battery from its holder and clip it into your phone.
2 Connect the travel charger to the phone and plug it into a
standard mains socket.
Powering On
1 Insert the SIM card into the tray on the back of your phone
(under the battery).
AThe i2000 supports a 3 Volt SIM card only.
2 Press S to switch on.
3 If prompted, enter your PIN code.
Once a GSM or iDEN network is located by your phone, it
connects and the network name appears on the display.
Making a Call
1 Enter the number you want to call.
AEven if you call a local number, you must include the full
area code but not the country code. However, to call a local
number when you are in the USA, you must include both
the country code and the area code.
AIf you make a mistake, press ´ once to move back one
digit, or select Cancl to start again.
2 Press ° to place the call.
IMPORTANT! Ending a Call
When you have finished your conversation, you must end the
call, even if the other person terminates the call. To end the call,
press
°.
AIf you do not end the call, you will remain connected and
you will be charged for the duration of the connection.
i2000_en.bk : intro.fm5 Page 3 Wednesday, February 23, 2000 7:58 AM