Sun Microsystems 2.0 - Manual (Page 32)

3-12 SunFastEthernet Adapter 2.0 Installation and User’s Guide—July 1996
3
3.6.4 Forcing Network Speed Between 10 Mbps and 100 Mbps
1. At the ok prompt, use the show-devs command to list the system devices.
You should see the full path name of the hme device, similar to the example
below:
2. Type:
3. Type the following, pressing the Return key at the end of line 0 :
4. Press the Control-C keys after typing (full path name of the hme device).
Note – In the above example, the speed is forced to 10 Mbps. To force the
speed to 100 Mbps, replace 10 with 100.
5. At the ok prompt type:
6. Reboot your system.
Refer to the Platform Notes: The hme Fast Ethernet Device Driver document (Part
No: 802-5333) for more information on the
hme device driver and forcing
network speed. This document is also available on the Solaris 2.5 and the
Solaris 2.5: 1/96 AnswerBook.
/iommu@f,e0000000/sbus@f,e0001000/SUNW,hme@3,8c00000
ok nvedit
0: probe-all install-console banner
1: apply transfer-speed=10 (full path name of the hme device)
ok nvstore
ok setenv use-nvramrc? true