3 booting from the network using solaris 2.4, At the ok prompt type, Type – Sun Microsystems 2.0 User Manual

Page 28: Press the control-c keys after typing device-end, At the ok prompt, type

3-8

SunFastEthernet Adapter 2.0 Installation and User’s Guide—July 1996

3.5.3 Booting From the Network Using Solaris 2.4

The device name of newer SBus cards for Solaris 2.5 is identified by a
“SUNW,” prefix. If your system is running Solaris 2.4, it will not recognize the
device. Perform the following tasks to set up your system so the device driver
can recognize the SunFastEthernet Adapter.

1. At the

prompt type:

The

show-devs

command lists the system devices. You should see the full

path name of the

hme

device, similar to the example below:

2. Type:

3. Type the following exactly as shown, spaces and quotation marks

included, pressing the Return key at the end of lines

and

4. Press the Control-C keys after typing

device-end

5. At the

prompt, type:

Your system will reset and the banner will appear.

ok setenv use-nvramrc? true

ok show-devs

/iommu@f,e0000000/sbus@f,e0001000/SUNW,hme@3,8c00000

ok nvedit

0: probe-all install-console banner

1: cd

(full path name of the hme device)

2: “ hme” nameprop

3: device-end

ok nvstore

ok reset