beautypg.com

Network controls – Smart Technologies Smart Board 800ixe-SMP User Manual

Page 96

background image

These commands inform you of the current audio output settings.

Command

Response

get volume

volume=[current volume setting]

get mute

mute=[current mute setting]

get volumecontrol

volumecontrol=[current volume control setting]

These commands control your projector’s audio amplifier settings. See Value-based command

methods on page 80 for setting absolute and adjustment commands.

Command

Command target range

Response

set volume [value]

=-20 to =20

volume=[value]

set mute [target]

=on

=off

mute=[target]

set volumecontrol [target]

=on

=off

volumecontrol=[target]

Network controls

These commands control your projector’s network status and settings. These settings are located in

the OSD, and are available even when the projector is in Standby mode. You must locally set the

network and VGA out commands to on for the network abilities to work.

These commands inform you of the current network settings.

Command

Response

get netstatus

netstatus=connected

netstatus=disconnected

netstatus=disabled

get dhcp

dhcp=[current DHCP status]

get ipaddr

ipaddr=[current IP address]

get subnetmask

subnetmask=[current subnet mask number]

get gateway

gateway=[current network gateway]

get primarydns

primarydns=[current primary domain server]

get macaddr

macaddr=[current MAC address]

These commands control your network settings.

Command

Command target range

Response

set dhcp [target]

=on

=off

dhcp=[current]

set ipaddr [target]

=0.0.0.0 to =255.255.255.255

ipaddr=[current]

set subnetmask [target]

=0.0.0.0 to =255.255.255.255

subnetmask=[current]

set gateway [target]

=0.0.0.0 to =255.255.255.255

gateway=[current]

set primarydns [target]

=0.0.0.0 to =255.255.255.255

primarydns=[current]

A P P E N D I X

B

Remotely managing your system through an RS-232 serial interface

86