beautypg.com

Resetting the lamp hours, Resetting the lamp hours on the – Smart Technologies Smart Board 800ixe-SMP User Manual

Page 61

background image

Resetting the lamp hours

After you replace the lamp module, you need to access the projector service menu and reset the lamp

hours. To prevent accidental errors, only a system administrator should perform this procedure.

N O T E

Always reset the lamp hours after you replace the lamp, because lamp service reminders are based

on the current hours of use.

g

To reset the lamp hours

1. Using the remote control, press the following buttons quickly to access the service menu:

Down, Up, Up, Left, Up.

C A U T I O N

Do not adjust any settings in the service menu other than those listed in this guide. Changing

other settings can damage or affect the operation of your projector and may invalidate your

warranty.

2. Scroll down to Lamp Hour Reset, and then press Enter.

C A U T I O N

Do not reset the lamp hours unless you have just replaced the lamp module. Resetting the

lamp hours on an old lamp can damage your projector as a result of lamp failure.

3. Scroll down to the Exit field, and press Enter to exit the projector service menu.

C H A P T E R 6

Maintaining your interactive whiteboard system

51