beautypg.com

Usb control settings, Network settings – Smart Technologies Smart Board 800ixe-SMP User Manual

Page 83

background image

Submenu setting

Description

Startup Screen

Sets the type of startup screen to SMART or User. The SMART
screen is the default SMART logo on a blue background. The User
screen uses the saved picture from the Capture User Startup Screen
function.

High Speed Fan

Adjusts the speed of the projector’s fan. Select High or Normal.

N O T E

Use the High setting when the projector’s temperature is high or the
altitude is above 6000' (1800 m).

Projector Mode

Adjusts the projection mode to Front, Ceiling, Rear or Rear Ceiling.

I M P O R T A N T

SMART recommends that you never change this setting from the
Ceiling projection mode.

Source

Adjusts the input source to VGA-1, VGA-2, Composite, S-Video or
HDMI.

USB Control settings

This menu allows you to associate a video source with a USB receptacle on the ACP.

Submenu setting

Description

USB1 Source

Enables touch for the selected video source (VGA-1, VGA-2, HDMI
or Disabled) by associating the video source with the room computer
USB receptacle (USB1) on the ACP.

USB2 Source

Enables touch for the selected video source (VGA-1, VGA-2, HDMI
or Disabled) by associating the video source with the laptop USB
receptacle (USB2) on the ACP.

T I P

These settings are only available for SMART UX60 projectors running DLP firmware version

1.0.0.4 or later.

Network settings

This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the

network-related addresses and names when DHCP is not used.

A P P E N D I X

A

Remotely managing your system through a network interface

73