beautypg.com

Smart Technologies Smart Board 800ixe-SMP User Manual

Page 60

background image

g

To put the new lamp module into the projector

1. Remove the new lamp module from its packaging.

2. Carefully place the lamp module into the projector using the handle on the top of the module.

Hold the lamp module vertically and guide it into its slot. Gently press the power end of the

lamp module against the projector to ensure the power plug makes contact with the projector’s

power receptacle.

3. Secure the captive screws using the Phillips screwdriver.

4. Carefully slide the lamp cover back onto the projector.

5. Connect the power cable to the wall outlet.

6. Press the Power

button once on the remote control or ACP to confirm that the projector is

operating and that the lamp module is correctly installed.

7. Put the old lamp in a secure container, and handle it gently until you recycle it.

g

To finish the projector lamp installation

1. Turn on the projector.

2. Access the service menu to reset the lamp hour counter (see Resetting the lamp hours on the

next page).

3. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see E-mail

alerts on page 75 and Control panel on page 70).

C H A P T E R 6

Maintaining your interactive whiteboard system

50