Smart Technologies Smart Board 800ixe-SMP - Manual (Page 100)

Command Command target range Response
set usb1source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
set usb2source [target] =vga1
=vga2
=hdmi
=disabled
usb1source=[target]
T I P
The set usb1source and set usb2source commands are only applicable to SMART UX60
projectors running DLP firmware version 1.0.0.4 or later.
N O T E
The Network and VGA Out setting’s features are off by default. Select on to activate these
features.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
90