beautypg.com

Additional vga source controls – Smart Technologies Smart Board 800ixe-SMP User Manual

Page 94

background image

Command

Command target range

Response

set red [value]

=0 to =100

red=[value]

set green [value]

=0 to =100

green=[value]

set blue [value]

=0 to =100

blue=[value]

set cyan [value]

=0 to =100

cyan=[value]

set magenta [value]

=0 to =100

magenta=[value]

set yellow [value]

=0 to =100

yellow=[value]

set videofreeze [target]

=on

=off

videofreeze=[target]

set cc [target]

=cc1

=cc2

=off

cc=[target]

N O T E

Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such

as French or Spanish, depending on television channel or media setup.

Additional VGA source controls

Your VGA source supports all the general source controls described in General source controls on

the previous page, as well as the commands listed in this section. These settings are unavailable

when the projector is in Standby mode or when the VGA sources are disconnected.

N O T E

Some of these commands are invalid with HDMI input and Composite video sources, and will

return the response “invalidcmd=[command]”.

These commands inform you of the current VGA source settings.

Command

Response

get frequency

frequency=[current frequency offset setting]

get tracking

tracking=[current tracking offset setting]

get saturation

saturation=[current saturation setting]

get tint

tint=[current tint setting]

get sharpness

sharpness=[current sharpness setting]

A P P E N D I X

B

Remotely managing your system through an RS-232 serial interface

84