Smart Technologies Smart Board 800ixe-SMP - Manual (Page 46)

The following diagrams and table describe the components of the ACP.
Number Function
1 USB A receptacle (for USB drives)
2 Power button (for appliance only)
3 LCD touch screen
4 Mini USB B receptacles (x2) (connect to appliance and laptop)
5 2.0 mm male barrel connector to appliance (DC-out)
6 2.5 mm male barrel connector to power supply (DC-in)
7 15-pin connector (connects to ACP harness cable)
Using the LCD touch screen
The LCD touch screen on the ACP gives you control of some of the basic operations of your
interactive whiteboard system. Its different modes provides you with power mode controls, volume
controls, switches for inputs and applications, projector control and LCD settings. It also provides
system and status information.
Using Whiteboard mode
In Whiteboard mode, you can make digital notes in the drawing area and then distribute those
notes to meeting participants. You can also use Whiteboard mode to create new presentations
or to open existing ones. It’s easy to add pages and navigate from page to page.
Using Web mode
In Web mode, you can start the web browser to view websites and web-based applications.
You can write over those websites and applications, and then capture the marked-up screen
image to your Whiteboard presentation.
Using VGA2 mode
In VGA2 mode, you can follow the instructions to connect your laptop to the interactive
whiteboard system.
C H A P T E R 4
Using your interactive whiteboard system
36