Setting up the server hardware, Installation overview – Sun Microsystems Sun Fire X4100 M2 User Manual
Page 9
1
C H A P T E R
1
Setting Up the Server Hardware
This chapter contains the following topics:
■
“Installation Overview” on page 1
■
“Installing the Server Into a Rack With Optional Slide Rails” on page 2
■
■
“Powering On and Off the Server” on page 16
Note –
The information in this book applies to all Sun Fire™ X4100/X4100 M2 and
X4200/X4200 M2 servers, unless otherwise noted.
Installation Overview
After unpacking your server, perform the following tasks, which are described in the
documentation as indicated:
1. If desired, install the server into a rack using orderable slide-rails. See
the Server Into a Rack With Optional Slide Rails” on page 2
.
2. Connect all cables, peripherals, and power cords. See
illustration of the server’s back panel connector ports.
3. Power on and boot the server as described in
“Powering On and Off the Server”
4. Connect to the service processor as described in
.