Sun Microsystems Sun Fire X4100 M2 - Manual (Page 11)

Chapter 1 Setting Up the Server Hardware 3
Disassembling the Slide Rails Before Installation
Use this procedure to remove the mounting brackets from the slide-rail assemblies.
1. Unpack the slide-rails.
2. Locate the slide-rail lock at the front of one of the slide-rail assemblies, as shown
in FIGURE 1-1 .
3. Squeeze and hold the tabs at the top and bottom of the lock while you pull the
mounting bracket out of the slide-rail assembly, until it reaches the stop. See
FIGURE 1-1 .
4. Pull the mounting bracket release button toward the front of the mounting
bracket, as shown in FIGURE 1-1 , and simultaneously withdraw the mounting
bracket from the slide-rail assembly.
5. Repeat the procedure for the remaining slide rail assembly.
FIGURE 1-1 Disassembling the Slide-Rail Before Installation
Slide-rail lock
Mounting bracket
release button