Sun Microsystems Sun Fire X4100 M2 - Manual (Page 15)

Chapter 1 Setting Up the Server Hardware 7
4. Simultaneously pull and hold the slide rail release buttons on each mounting
bracket while you push the server into the rack. See FIGURE 1-4 .
Continue pushing until the slide-rail locks on the front of the mounting brackets
engage the slide-rail assemblies.
Caution – Verify that the server is securely mounted in the rack and that the slide-
rails locks are engaged with the mounting brackets before continuing.
Installing the Cable Management Assembly
Use this procedure to install an optional cable management assembly (CMA).
1. Unpack the CMA parts.
2. Take the CMA to the rear of the equipment rack and ensure that you have
adequate room to work around the rear of the server.
Note – References to “left” or “right” in this procedure assume that you are facing
the rear of the equipment rack.
3. Locate the CMA rail extension and insert it into the left slide-rail until the
extension locks into place with an audible click. See FIGURE 1-5 .
FIGURE 1-5 Inserting the CMA Rail Extension Into the Rear of the Left Slide-Rail
CMA rail
extension
Left slide-rail