Verifying operation of the slide rails and cma – Sun Microsystems Sun Fire X4100 M2 User Manual
Page 20
12
Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Installation Guide • May 2007
Verifying Operation of the Slide Rails and CMA
Use this procedure to ensure that the slide-rails and CMA are operating correctly.
Note –
Two people are recommended for this procedure: one to move the server in
and out of the rack and one to observe the cables and CMA.
1. Slowly pull the server out of the rack until the slide-rails reach their stops.
2. Inspect the attached cables for any binding or kinks.
3. Verify that the CMA extends fully and does not bind in the slide-rails.
4. Push the server back into the rack, as described below.
When the server is fully extended, you must release two sets of slide-rail stops to
return the server to the rack:
a. The first set of stops are levers, located on the inside of each slide-rail, just
behind the rear panel of the server. These levers are labeled “PUSH.” Push in
both levers simultaneously and slide the server toward the rack.
The server will travel approximately 15 inches (38 cm) and stop.
Verify that the cables and the CMA retract without binding before continuing.
b. The second set of stops are the slide-rail release buttons, located near the front
of each mounting bracket. See
. Simultaneously push or pull both of
the slide-rail release buttons and push the server completely into the rack until
both slide-rail locks engage.
5. Adjust the cable hangers and CMA as required.
6. Continue with