Sun Microsystems Sun Fire X4100 M2 - Manual (Page 40)

32 Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Installation Guide • May 2007
Installation Worksheet
Use the worksheet in TABLE 1 to gather the information you need to configure the
preinstalled Solaris 10 OS. You need to collect only the information that applies to
your application.
TABLE 1 Worksheet for Installation
Information for Installation Description or Example
Your Answers:
Defaults are noted
with an asterisk. (*)
Language Choose from the list of available languages for the
Solaris 10 software. English*
Locale Choose your geographic region from the list of available
locales. English (C - 7-bit
ASCII)*
Terminal Choose the type of terminal that you are using from the
list of available terminal types.
Network connection Is the system connected to a network? • Networked
• Non-networked*
DHCP Can the system use Dynamic Host Configuration
Protocol (DHCP) to configure its network interfaces? • Yes
• No*
If you are not
using DHCP,
note the network
address: IP address If you are not using DHCP, supply the IP address for the
system.
Example: 129.200.9.1
Subnet If you are not using DHCP, is the system part of a
subnet?
If yes, what is the netmask of the subnet?
Example: 255.255.0.0 255.255.0.0*
IPv6 Do you want to enable IPv6 on this machine? • Yes
• No*
Host name A host name that you choose for the system.
Kerberos Do you want to configure Kerberos security on this
machine? If yes, gather the following information:
Default Realm:
Administration Server:
First KDC:
(Optional) Additional KDCs:
• Yes
• No*