Sharp UX-340LM - Manual (Page 98)

Problems and Solutions
96
Dialing and transmission problems
Problem Solution
No dial tone when you pick
up the handset or press the
SPEAKER key. • Make sure the handset cord is connected to the
correct jack. See Connecting the handset on page 10.
Dialing is not possible. • Make sure the power cord is properly plugged into a
power outlet.
• Make sure that the telephone line is properly
connected to both the TEL. LINE jack and the wall
jack.
• Make sure that the fax machine is set to the correct
dialing mode for your telephone line. See Connecting
the telephone line cord on page 11.
The power is on, but no
transmission takes place. • Make sure that the receiving machine has paper.
• Make sure that the telephone line cord is plugged into
the TEL. LINE jack, and not the TEL. SET jack.
• If the receiving machine is in manual mode with no
attendant, reception will not be possible.
• Check the display for error messages.
• Pick up the handset and check for a dial tone.
Nothing is printed at the
receiving end. • Make sure that the document for transmission is
placed face down in the feeder.
A distorted image is
received at the other end. • Noise on the telephone line may cause distortion. Try
sending the document again.
• Make a copy of the document on your fax machine. If
the copy is also distorted, your fax machine may need
service.
all_ux340lm.book Page 96 Tuesday, November 28, 2000 3:09 PM