Sharp UX-340LM - Manual (Page 103)

Messages and Signals
101
11. T
roub
le
-
s
hooti
n
g
MEMORY IS FULL The memory is full. This may occur during fax reception
if too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional message
will indicate the problem), resolve the problem so that
printing can continue (see Substitute Reception to
Memory on page 60). If you are attempting to transmit
from memory, see If the memory becomes full on page
82.
MEMORY PRINTING The fax is preparing to or printing out a document from
memory.
NO DATA This appears if you attempt to search for an automatic
dialing number when none have been stored.
NO SERVICE This appears if you haven’t registered with OpenLCR
and press the FUNCTION key and 7.
NO # STORED You have tried to dial or clear a Rapid Key or Speed Dial
number that hasn’t been programmed (a full number
hasn’t been assigned to it).
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
ON HOOK DIAL The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
OUT OF PAPER You are out of printing paper (or the paper release plate
is open). Load paper as explained in Loading Printing
Paper on page 17.
OVER HEAT The print head has overheated. Operation can be
continued after it cools.
PAPER JAMMED The printing paper is jammed. See the following section,
Clearing Paper Jams.
READY TO SEND A document has been loaded and the fax machine is
waiting for you to begin faxing or copying.
RECALLING This appears if you attempt to send a fax by automatic
dialing and the line is busy or the receiving fax machine
does not answer. Your fax machine will automatically
reattempt the call. (See page 51.)
all_ux340lm.book Page 101 Tuesday, November 28, 2000 3:09 PM