Sharp UX-340LM - Manual (Page 58)

Using TEL Mode
56
Answering with an extension
phone
1
Answer the extension phone when
it rings.
2
If you hear a soft fax tone, wait until
your fax responds (the extension
phone will go dead if it is connected
to your fax, or you will hear
pronounced, high-pitched tones if
the phone is connected to a
separate wall jack), then hang up.
Phone goes dead
or pronounced,
high-pitched tones Beep
3
If the fax doesn't respond, or if the
other party first talks to you and
then wants to send a fax, press 5,
* , and * on the extension phone
(only on a tone dial phone). This
signals the fax to begin reception.
Hang up.
5
Comments:
♦
Your fax will not accept the signal to
begin reception (5
** ) if a
document is loaded in its feeder.
♦
If you have set the Fax Signal
Receive setting to NO, press 5,
*
,
and * on the extension phone to
begin reception.
Changing the number for
remote fax activation
If desired, you can use a number
other than 5 to activate fax reception
from an extension telephone. You can
select any number from 0 to 9.
1
Press these keys:
FUNCTION
Press 5
times
4
TEL/FAX REMOTE #
2
Press a number from 0 to 9 .
1
(Example)
3
Press the STOP key to return to the
date and time display.
STOP
all_ux340lm.book Page 56 Tuesday, November 28, 2000 3:09 PM