Sharp UX-340LM - Manual (Page 24)

Setting the Date and Time
22
Setting the Date and Time
1
Press these keys:
Set the date and time by pressing the
keys on the operation panel as shown
below.
The date and time appear in
the display and are printed at
the top of every page you fax.
3 key
* * * * key
FUNCTION key
STOP key START/
MEMORY
key
2 1 3
9
4 5 6
7 8
0
Note: The imaging film and printing
paper must be loaded before the date
and time can be set.
Do not set the date and time if
you are using OpenLCR!
OpenLCR automatically sets the
date and time each time your fax
calls OpenLCR and receives rate
data. To ensure accurate use of the
rate data, do not change the date
and time setting yourself.
OpenLCR also sets the date and
time for you if you perform the fax
transmission test (see page 30).
3
FUNCTION
Press 4
times
DATE & TIME SET
2
Press the START/MEMORY key.
START/MEMORY
•
The currently set date will appear in
the display.
3
Enter a two-digit number for the
month (“01” for January, “02” for
February, “12” for December, etc.).
Example: January
0 1
•
To correct a mistake, press the
SPEED DIAL key to move the
cursor back to the mistake and then
enter the correct number.
The display will show:
all_ux340lm.book Page 22 Tuesday, November 28, 2000 3:09 PM