Sharp UX-340LM - Manual (Page 67)

65
7. Ans
w
er
ing
Mac
h
ine
7. Answering Machine Hookup
Connecting an Answering Machine
If desired, you can connect an answering machine to your fax machine's TEL. SET
jack. This will allow you to receive both voice messages and faxes when you are out.
1
Remove the seal covering the TEL.
SET jack.
TEL.
SET TEL. LINE
To answering machine's
telephone line jack.
2
Connect the answering machine's
telephone line jack to the TEL. SET
jack.
•
If desired, you can connect an
extension phone to your answering
machine's extension phone jack.
Changing the outgoing
message
The outgoing message (OGM) of
your answering machine should be
changed to inform callers who want
to send a fax to press their Start key.
For example, your message might go
as follows:
"Hello. You've reached the ABC
company. No one is available to take
your call right now. Please leave a
message after the beep or press your
facsimile Start key to send a fax.
Thank you for calling."
♦
Try to keep the length of the
message under 10 seconds. If it is
too long, you may have difficulty
receiving faxes sent by automatic
dialing.
♦
If your outgoing message must be
longer than 10 seconds, leave a
pause of about four seconds at the
beginning of the message. This will
give your fax a chance to detect fax
tones sent when automatic dialing
is used.
Make sure the
TEL. LINE jack
is connected to
the wall jack.
all_ux340lm.book Page 65 Tuesday, November 28, 2000 3:09 PM