Siemens 2614 - Manual (Page 26)

4-2
Figure 4-2. Select Network Protocol
6. The TCP/IP protocol will be listed in the Network window. Click OK to complete the install
procedure, and restart your computer to enable the TCP/IP protocol.
Configure TCP/IP for the SpeedStream 2614
When TCP/IP is installed on your computer, follow these instructions to configure it for the SpeedStream
2614:
1. On the Windows taskbar, click Start | Settings | Control Panel.
2. Double-click the Network icon; then click the Configuration tab and select the TCP/IP for your
network card.
3. Click the Properties button to enter the TCP/IP properties for the SpeedStream 2614. You can
dynamically assign TCP/IP address settings to a client, or you can manually configure a client with
address settings to meet your specific network requirements. (Note that the default IP address of the
SpeedStream 2614 is 192.168.254.254.)
Dynamic IP Allocation via a DHCP Server
1. On the IP Address tab, select Obtain an IP address automatically.
2. Do not enter any values under the Gateway tab.
3. On the DNS Configuration tab, select Disable DNS. These settings will be automatically configured
by the DHCP server.