Sharp PC-MM1 - Manual (Page 86)

6-2
6
Entering and Exiting Setup Utility
1. Turn on your computer.
2. When Press to enter SETUP appears, press F2.
3. Change to the desired settings. Refer to the next section.
4. Select Exit menu; then, press Enter.
5. Select one of the exit methods, and press Enter.
6. Confirm the message and press Enter again. The system restarts.
When the Setup Utility is opened, power management does not work. Do
not close the display cover.
Changing Setting of Setup Utility
To change the settings:
1. Use
→ or ← key to select the menu.
2. Use ↑ or ↓ key to select the item.
Minus or Space key : Changes the value.
In the item with mark, press Enter to open a sub menu. Press Esc to close the
sub menu and return to the previous menu.
For date and time, press Enter on the item to select the value you want to
change; then, use minus key or space bar to change the value.
3. Close the Setup Utility by following the steps above.