Sharp PC-MM1 - Manual (Page 59)

4-9
4
3. Place your CD onto the disk spindle and press on the center of your CD with
label side up, until it locks onto the disk spindle.
L ABEL
4. Close the disk cover.
• Insert a CD firmly until it is locked onto the spindle; then, close the
disk cover, or the disk may fall off the spindle and get damaged.
• Do not leave the tray open. Also, avoid touching the lens in the tray. If
the lens becomes dirty, the CD-ROM may malfunction.
• Do not wipe the lens with materials with rough surface (such as paper
towels). Instead, use a cotton swab to gently wipe the lens.
Removing CD
1. Make sure the busy indicator is not lit.
2. Slide the cover latch to the right and open the cover.
3. Press down the disk spindle and remove the CD from the tray holding its edge.
• Make sure the busy indicator is not lit or blinking before opening the
disk cover.
• When opening the cover, if the CD is still spinning, wait until it has
stopped, then remove it.