Setting e1000g driver parameters, Setting, To set driver parameters using the – Sun Microsystems Ethernet MMF/UTP Adapter User Manual
Page 78
44
Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
The Sun PCI-Express Dual Gigabit Ethernet ExpressModule performs
autonegotiation with the remote end of the link (the link partner) to select a common
mode of operation.
The Sun PCI-Express Dual Gigabit Ethernet ExpressModule also supports a non-
autonegotiated mode of operation. You can set the speed and mode using the ndd
utility, or, to make sure the changes persist after a system reboot, you can create a
e1000g.conf
file. See
“To Set Driver Parameters Using the e1000g.conf File” on
for more information about setting driver parameters.
The Sun PCI-Express Dual Gigabit Ethernet UTP ExpressModule is capable of all the
operating speeds and modes listed in
“Setting Parameters Using the ndd Utility” on
. The e1000g device performs autonegotiation with the remote end of the
link (link partner) to select a common mode of operation. The e1000g device also
supports Forced mode operation.
Setting e1000g Driver Parameters
You can set the e1000g device driver parameters using the e1000g.conf file
To set parameters so they remain in effect after you reboot the system, create a
/kernel/drv/e1000g.conf
file and add parameter values to this file when you
need to set a particular parameter for a device in the system.
▼
To Set Driver Parameters Using the
e1000g.conf
File
1. Edit the /kernel/drv/e1000g.conf file:
You should see output similar to the following:
# vi /kernel/drv/e1000g.conf
# Driver.conf file for Intel e1000g Gigabit Ethernet Adapter
#
# Copyright (c) 2002, by Intel, Inc.
# All Rights Reserved.
#
#ident "@(#)e1000g.conf 1.1 98/09/22 Intel"
#