Sun Microsystems Ethernet MMF/UTP Adapter - Manual (Page 60)

26 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
1. Set the following driver parameters to the values that are described in the
documentation that shipped with your link partner (for example, a switch):
■ adv-1000fdx-cap
■ adv-100fdx-cap
■ adv-100hdx-cap
■ adv-10fdx-cap
■ adv-10hdx-cap
■ adv-asmpause-cap
■ adv-pause-cap
See TABLE 3-5 for the descriptions and possible values of these parameters.
Note – According to IEEE 802.3 specifications, when using 1000 Mbit/sec speed
over copper media, autonegotiation is not optional. In the absence of
autonegotiation, (for example, while using Forced mode), link syncing between link
partners may not happen and the link may not come up.
2. Set the adv-autoneg-cap parameter to 0.
When you change any ndd link parameter, a message similar to the following is
displayed:
Setting Parameters Using the ipge.conf File
Specify the driver parameter properties for each device by creating a ipge.conf file
in the /kernel/drv directory. Use a ipge.conf file when you need to set a
particular parameter for a device in the system. The parameters you can set are the
read and write parameters listed in
“Sun PCI-Express Dual Gigabit Ethernet Device
Driver Parameters” on page 34 .
The man pages for prtconf(1M) and driver.conf(4) include additional details.
The next procedure shows an example of setting parameters in a ipge.conf file.
● To access any man page, type the man command plus the name of the man page.
For example, to access man pages for prtconf(1M), type:
# ndd -set /dev/ipge adv-autoneg-cap 0
xcvr addr:0x00 - link up 100 Mbps full duplex
% man prtconf