Sun Microsystems Ethernet MMF/UTP Adapter - Manual (Page 62)

28 Sun PCI-Express Dual Gigabit Ethernet MMF/UTP Adapter Installation and User’s Guide • June 2006
■ unit-address = "1"
2. Set the parameters for the ipge devices in the
/kernel/drv/ipge.conf file.
In the following example, the adv_autoneg_cap and adv_1000fdx_cap
parameters are set for all Sun PCI-Express Dual Gigabit Ethernet devices. See the
driver.conf(4)
man page for more information.
In the following example, the adv-autoneg-cap and adv-1000fdx-cap
parameters are set for a single instance of the ipge device.
Note – If you omit the name=, parent=, and unit-address= definitions, the
settings become global to all Sun PCI-Express Dual Gigabit Ethernet instances.
3. Save the ipge.conf file.
Link Partner Parameters
TABLE 3-1 describes the read-only link partner capabilities.
adv-autoneg-cap=0 adv-1000fdx-cap=0;
name="pciex8086,105f" parent="/pci@7c0/pci@0/pci@2/network@0" unit-address="1"
adv-autoneg-cap=0 adv-100hdx-cap=0 adv-100fdx-cap=1 adv-1000fdx-cap=0 adv-
10hdx-cap=0 adv-10fdx-cap=0 adv-1000hdx-cap=0 adv-100T4-cap=0;
TABLE 3-1 Read-Only Link Partner Capabilities
Parameter Description
lp_cap_autoneg 0 = No autonegotiation
1 = Autonegotiation
lp_cap_1000fdx 0 = No 1000 Mbit/sec full-duplex transmission
1 = 1000 Mbit/sec full-duplex
lp_cap_1000hdx 0 = No 1000 Mbit/sec half-duplex transmission
1 = 1000 Mbit/sec half-duplex
lp_cap_100fdx 0 = No 100 Mbit/sec full-duplex transmission
1 = 100 Mbit/sec full-duplex