Savin 3360DNP User Manual

Page 167

User Tools Menu

147

Deflector Angle

You can change the angle of the wing guide depending on the pa-
per type you use.

Note

❒ Default: Auto
❒ Available settings:

• Up (Select this setting when standard thickness or thin pa-

per misfeeds at the paper exit section occur frequently.)

• Down (Select this setting when A4 – B5, 8

× 11" thick

paper is not delivered properly to the paper delivery tray.)

Auto Class

When you do not use the Separation mode, you can select the ma-
chine's condition after each printing set is fed out to the paper de-
livery tray.

Note

❒ Default: Stop
❒ Available settings:

• Start printing automatically (After the last page of each

printing set is fed out to the paper delivery tray, the ma-
chine stops for a few seconds. Then, the next cycle begins.)

• Stop (After the last page of each printing set is fed out to

the paper delivery tray, the machine stops. If you press the

{{{{Print}}}} key, the next cycle begins.)

Auto Separate

Specifies whether Job Separation mode is automatically carried
out when you make prints in All Class, Auto Class, Manual Class,
or Class mode.

Note

❒ Default: ON

Ink/Master Left

Specifies whether you can check the amount of ink and master.

Note

❒ Default: OFF
❒ Available settings:

• OFF (You cannot check the remaining amount of ink or

master.)

• ON (When the remaining amount of ink or master is less

than half, the panel display indicates these amounts when
you turn on the main switch.)

• Check remaining volume (You can see the remaining

amounts of ink and master regardless of these amounts.)

Type of Paper

When one kind of paper misfeed occur frequently, you can regis-
ter its paper type in “User1” or “User2”.

Reference

For registering a special paper type, see p.158 “4-19 Type of
Paper”.

No.

Mode

Description