Sun Microsystems SunFastEthernet Adapte - Manual (Page 73)

Running Diagnostics C-7
C
C.2.2 The Sundiag Window
Note – The SunFast Ethernet Adapter is not supported in Sundiag for Solaris
1.x.
Note – Examples in this section show Sundiag running in the OPEN LOOK®
environment. Sundiag run in the SunView™ environment will look different.
To start Sundiag, cd to the Sundiag directory (/opt/SUNWdiag/bin/sundiag)
and then type the sundiag command. After you enter the
sundiag command,
the Sundiag window is displayed on your screen, refer to Figure C-1. This
window is the primary interface for running Sundiag. Refer to the Sundiag
manual that came with your operating system for further details.
The Sundiag window is divided into four small windows:
•
The system status window at the upper-left of the screen displays the status
of the tests.
•
The performance monitor panel in the upper-middle of the screen displays
the performance statistics for the system that is under test.
•
The control panel is located at the right. The panel includes buttons,
exclusive choice, toggle, and pop-up menus that allow you to select test
parameters and options.
• The console window at the bottom-left displays test messages, and allows
you, as a superuser, to use operating system commands.