Sun Microsystems SunFastEthernet Adapte - Manual (Page 25)

Installing the SunFastEthernet SBus Card 2-5
2
b. If the system has OpenBoot PROM 2.3 to 2.5, use the watch-net
command.
5. Set the diag-switch to false.
At the ok prompt type:
<#0> ok watch-net
Qe register test -- succeeded.
Internal loopback test -- succeeded.
Transceiver check -- 100 mbps Link Down, 10 mbps Link Up, passed.
Tx/Rx enable/disable test--succeeded
Frame counter test--succeeded
Address detection test--succeeded
Address hash test--succeeded
Looking for Ethernet packets.
‘.’ is a good packet. ‘X’ is a bad packet.
Type any key to stop.
...............................................................
...............................................................
.................................
<#0> ok
ok setenv diag-switch? false